Chrysler Crossfire
Turn signal light adapter

This is one information page of my collection of what I have repaired on my Crossfire.

Note:
You should not do any repair on your car if you don't have enough experience and knowledge! You use this information at your own risk! Don't blame me if something goes wrong.

Content:

• Main Content Chrysler Crossfire DIY
  1. Turn signal, 3D-print adapter
  2. Turn signal, Prototype no 2
  3. Turn signal, Lock mechanism and guiders
  4. Turn signal, The last design
  5. Turn signal, Electric connection
  6. To be continued

Crossfire share most of it's chassis parts with Mercedes SLK R170 with the 320 engine.

Turn signal lights:

Note:
In Sweden and most other countries the lights on a car must be certified. In Europe we have E-standard.

More information at Wikipedia:

• https://en.wikipedia.org/ wiki/ Automotive lighting
• https://sv.wikipedia.org/ wiki/ Fordonsbelysning/ Teknikbegrepp

2, Prototype no 2:

Prototype no 2 at bottom. The lower edge is extended by 4 mm.

At the other end the corner got a bigger diameter. But did some mistake, the height increased too.

Much better fit, to the left it need to extend 2 more mm.

The upper profile to the right must be corrected. Need to increase the height by 2 mm.

I must also implement some tabs that center the holder in the opening. And on the backside, some hooks that hold it in place.

The holder is three mm higher than the opening, maybe I shall increase the height of it by one or two mm.