Chrysler Crossfire
Anti theft alarm
This is one information page of my collection of what I have repaired on my Crossfire.
Note:
You should not do any repair on your car if you don't have enough experience and knowledge!
You use this information at your own risk! Don't blame me if something goes wrong.
Content:
Note:
You have to work with the electric parts.
Disconnect the battery, the negative terminal !
When disconnecting the battery the alarm and radio will be reset, be sure to have any codes that's needed!
|
|
6, Door switches:
How about the doors, when open the interior light switch on, could it still be some problem.
The right ajar door switch looks to have two switches as the glow compartment had.
Or have they done some mistake, the hood switch are missing, is that the second right ajar door switch ?
At one place they say that the driver lock switch is an integral part of the driver door lock actuator, this could also be the second door switch in the schematics.
Door switch location:
I looked around the left door if there were more than one switch, but only found this one.
It's the same on the right door.
It's located close to the door mechanical lock.
This switch turns on/off the interior light.
First I must figure out how to pull out the switch without destroying it.
|
When looking in the schematics there should be two switches for the right door.
Maybe they have divided it, one for the interior light and one for the theft alarm.
But more likely that the schematic is wrong because the hood switch is missing.
The second right ajar door switch could be the missing hood switch.
This door switch only have two wires and one switch.
I couldn't find any more switches in the door.
This switch has the part number: 2028202110 and can be find here:
Door contact switch.
To remove it from the car, put a small screwdriver in the upper rectangular hole to release the hook.
Be careful, it's easy to brake.
|
|
|
English
Svenska